Jump to content
View in the app

A better way to browse. Learn more.

Mopar1973Man.Com LLC

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.
Posted

my truck is not starting ?!!!!! when i go to start it, it just cranks and cranks im not getting any power to my lift and inj. pump. truck is stock but a couple people told me it was a bad ecm ? went threw the wires they seemed fine noticed im not getting rpms though when its cranking. so i replaced the crank sensor. still not moving. i got the lift pump to run with the relay jumped but plug it back in and it dosent fire up need some help maybe a wire diagram ??or just some expert thoughts !thanks !

  • Replies 6
  • Views 1.8k
  • Created
  • Last Reply

Top Posters In This Topic

Featured Replies

Have you checked for codes? Check the PDC under the hood. See if you have a blown fuse for the LP. Exchange with a like fuse and see if you get fuel.

  • Author

yea everythings fine i checked the pdc no fuses are blown and when i hooked it up to the scanner it couldnt communicate with computer

did you check to see there are any bad fuses under hood? Is there there a comm fuse?Also make sure the batteries are up and good clean terminals.... Did this just happen all of the sudden?

I understand the engine turns over. Have you checked all the "other" wires connected to the batteries? I had my lift pump cut out, was traced to a connection a few inches from the passenger's side battery. Check the grounds too.

  • Author

I understand the engine turns over. Have you checked all the "other" wires connected to the batteries? I had my lift pump cut out, was traced to a connection a few inches from the passenger's side battery. Check the grounds too.

Ill check again were is the comm fuse ? O yeah and my wts light doesn't turn on at all

Ill check again were is the comm fuse ? O yeah and my wts light doesn't turn on at all

The WTS and the scanner not communicating with the truck is sounding like you hava a ECM issue. Unfortunately I dont know how to tell you to check it.

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.