Questions about intake things

[Evan]

I did notice egt's getting slightly lower with 5" 

Not sure it would have been enough to justify if I didnt fab it for as inexpensive as I did

 

only mods I've done that made a noticable improvement and was 100% worth the time and effort have been trans upgrades and track bar ohh injectors to but those were a needed upgrade. Maintenance wear upgrade

 

Almost everything else motor wise has been for fun because I like tinkering. 

[Silverdodge]

Right now 

[Silverdodge]

And now I bought rims ugh it never ends 

[Silverdodge]

Here u guys go

[Evan]

You think getting rid of the heat grid helps any?

[Silverdodge]

No that's silly but something like this probably would 

[Mopar1973Man]

I doubt a 4th gen intake plate will fit. I'll have to get a picture of the setup since I have got a 2012 Ram in the shop doing injectors on already.

[Silverdodge]

Mike I'm a machinist I can make the horn fit if the bed plate fits but but I would have to get custom bent lines or some other odd thing 

And at that point making a bed plate on a cnc would be childs play 

[Mopar1973Man]

That's what I'm talking about the plate not the horn. The horn will fit no matter what. It the base plate and the integrated grid heater. Grid heater is below the plate not above like on our trucks. 

Edited April 30, 2019 by Mopar1973Man

[Silverdodge]

They make kits to put it on the inbound side of the horn