Posted March 23, 20169 yr Just got my new high idle switch installed and everything seems to work great. Question is if I start it in 6cyl mode and get in the truck to leave should I hit the brake to stop high idle before turning the switch to off?
March 23, 20169 yr Doesn't matter, the brake will only restart the high idle ramp up process. The disable of the high idle is built into the ECM programming so you really dont have to worry. The only way to truly disable the high idle is to reach operating temp or to turn the truck off for 30 seconds. think of it this way, the switch really only flips the switch for high idle on, it can't flip the switch off. Also post some pictures!!! Edited March 23, 20169 yr by Me78569
March 23, 20169 yr Author Ok that's what I was thinking. I was just concerned about forgeting to turn it off for the next key cycle in case I didn't need it. I will put some pics up tomorrow, it's dark here in my part of the world!
March 23, 20169 yr It is hard to remember to turn it to off, but it will never cause an issue just a 30 second today while you turn the key off. You can switch between modes on the switch with no issues.
March 23, 20169 yr If you're like me and forget to turn the switch to off before you start every morning it may throw a code (forget what number) that basically says it's not seeing any temp difference in you IAT temps but from my experience it didn't effect anything and it also went away by just starting the truck making sure the switch is off.
March 23, 20169 yr Author So it is safe to switch it off while the truck is running? I noticed moparman saying selecting modes while running is possible but not recommend or is that just turning it on while running?
March 23, 20169 yr %100 safe to switch on the fly. We don't recommend it because you might throw a code.
March 23, 20169 yr Owner Best to set the mode of high idle before starting. Then after its starting ramping up you may change mode to MPG or OFF. The only mode you can leave for extended time is 6 CYL this mode will not cancel by coolant temperature. This will keep it from canceling for times like jumping starting another vehicle. But if you start with 6 CYL and then flip to OFF after ramping occurs it will cancel normally with coolant temperature.
March 23, 20169 yr Author OK that is what I thought, I just couldn't make it clear to myself based off the wording on the general operation thread. As always, thanks again!
Just got my new high idle switch installed and everything seems to work great. Question is if I start it in 6cyl mode and get in the truck to leave should I hit the brake to stop high idle before turning the switch to off?