Jump to content

Will not start

Posted

Truck will not start. Turn the ignition switch and nothing. Have power to everything else. New starter, batteries, no codes checked fuses, changed starter relay in PDC. Happened last week and had the starter retested and put it back in and it started right up! I have gremlins. Looking for suggestions. Thanks!

  • Replies 23
  • Views 3.4k
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Most Popular Posts

  • IBMobile
    IBMobile

    Try this, connect a 14-12 gauge wire to the starter solenoid terminal that the brown wire from the starter motor relay attaches.  Place an alligator clip to the other end of the wire and the wire shou

  • Mopar1973Man
    Mopar1973Man

    This should help...

  • gassernomore
    gassernomore

    Well, it happened again! Used IBM's wire and the starter did not engage. 30 miles from home. Lucky my son was one mile away on a service call. Pulled the starter and put a new one in. Life is good aga

Featured Replies

at about 260K my original starter kept sticking in the engaged position....found a local rebuild one for a good deal so I swapped it in.  No issues yet.  Still have my original started in a box on the shelf couldn't bring myself to get rid of it.

Wish I would have kept mine when the contacts went on it also. Did not know any better. Bought a new from Advance auto for $100 bucks with the lifetime warranty and they have replaced it once so far. But I might be doing it again in the near future. Mine seems to be getting a little weak.

Go to topic listing