Well this morning it was pretty frozen i we iced the truck etc drove maybe 5 miles went to clean the screen using the washers but the wipers froze. now i only have wipers working on fast no intermittent and no washer/wipers when the washer button is pressed anyone had this issue? Is there a fuse for this part of the circuit?? Thanks

 

Here is what they look like underneath.  

I pack mine with a thin layer of axle grease to prevent oxidizing of the aluminum and make them easier to come back off in the future. 

Yeah I've sprayed them up good i will try again tomorrow cant believe how expensive the arms are in comparison to a new motor... 

Ronnie,

I hope they come off for you... they can be a pain!!!   You may want to try a little bit of heat too, if you have a heat gun (or just a hair dryer.)  this also may help working some penetrating oil in there. 

 

In the old days of US cars, the wipers had a center bolt.  So you could use a special puller (like a gear puller) to get the suckers off.....  Hey just think, this (the new clipped slip ons) saved a good 3 minutes per vehicle during manufacturing!!!!  It doesn't matter that it is a nightmare for you now!

 

Hag

You have to raise up on the hinged part of the arm before sliding the pin out.

@Haggar yeah European cars are like that much easier i will try some heat when i have 5 minutes away from work..

 

@98whitelightnin yeah it's just seized on the spline i have been lifting the wiper to slide the clip out

 

Did you ever get this issue resolved? I put in a new motor today but still have no intermittent mode. Can the CTM be swapped with a junk yard unit easily?

On 4/1/2019 at 11:33 PM, 98whitelightnin said:

Did you ever get this issue resolved? I put in a new motor today but still have no intermittent mode. Can the CTM be swapped with a junk yard unit easily?

Sorry just seen this my issue turned out to be a failed column switch I think you guys call the a multi function stick? Hope this helps!

22 minutes ago, Ronniemx3 said:

I think you guys call the a multi function stick?

 

Yes it's a multi-function stick/switch.

 

I replaced mine and intermittent still doesnt work.

 

This should help out. 

The CTM was actually unplugged. I guess po got tired of the door dinger.