Jump to content
Posted

I have race truck mirrors on my truck. Have lived with them for about 15years. I now have welder in the back window so only have mirrors. The race truck mirrors look good but I cant see **** so many blind spots and no view when turning my head to see ttaffic.

 

https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F232151453539

 

These caught my eye. I dont care that they have led. Dont even really care if there manual or powerd adjust. I think they look good and should improve rear and side view.

 

Driving our dump truck is a better experience because I can see so much better.

 

What mirrors is everyone running. I always look to ebay first for most parts like this.

 

Thanks for any replied

  • Replies 41
  • Views 4.5k
  • Created
  • Last Reply

Top Posters In This Topic

Most Popular Posts

  • 98whitelightnin
    98whitelightnin

    Not the best pics since it’s in the driveway but here they are.

  • hdpwipmonkey
    hdpwipmonkey

    Nope, no shake.  I was a little hesitant buying cheap mirrors but so far so good.  I did have one issue with one of the mirrors.  One of the studs that screw into the mirror then goes through the back

  • hdpwipmonkey
    hdpwipmonkey

    These are the ones that I got.  They have the backing plate included.  No shakes except when I close the doors.  

Posted Images

Featured Replies

I just fitted a pair of these 

K SOURCE 60180C {#CH1320307} Textured Black Info
Towing Style; Left; Heated Power Foldaway; w/ Towing Package; Spot Mirror; flip out Head
 
from Rockauto. if you search on 1998 they come up as seperate left and right, if you search 2002 same mirrors are either individual or as a boxed pair, the pair works out a little cheaper but to be honest by the time they get here they are expensive, both mirrors were $243 ish, shipping $53, well over £350 by the time they got here.
They don't vibrate, fit was ok but not quite right especially drivers side as there is a screw and a clip that secures the mirror wiring and it just doesn't allow the mirror to fit flush to the door, I just removed the clip and screw I also had to trim a little off of the back of the mirror position switch as it was catching on one of the nuts but that was only a shaving, the spot mirror is top outside until folded out then bottom outside, visibility seems good but not driven it yet