Jump to content

2nd Edge Ez in the Can

Posted

I started hearing a louder clatter in my eng about two weeks ago and just blew it off as colder temps in the morning. Well it blew smoke at ambient temp of 65 and when I accellerated it smoked blue a little heavy so went to shop and disconected Edge Ez and no more clatter and no more smoke. What the heck is up with that?Also my boost elbow is still hooked up, I have not thrown any codes yet, should I leave it hooked up or is it defeating it's purpose? The last time I left it hooked up it kept throwing codes.

  • Replies 8
  • Views 2.4k
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Featured Replies

  • Owner

Common problems with Edge EZ is that its mounted under the hood it get hot and cold. Then the case isn't sealed very good and I've several get water inside and corrode the circuit board...Edge Comp is mounted in the cab... No issues here...

Interesting cuz I have a friend here with an EZ that quit working. I'll maybe tell him about this.

  • Author

Yea this is the one they sent in replace of the last one. Cant say anything bad about them they sent the new one right away. The only thing is it set on the shelf for three months while I had trouble with the old motor, then I didnt run it till I was sure this motor was going to hold up and I bet it dont have three months under the hood. And the old one was corroded big time, big 10-4 on the under the hood problem.

Have you contacted edge about it?

Strange all the juices are underhood ... Not heard of issue wonder if ez only ??

  • Author

I dont know but I know I am done with the EZ. Now that I have had it unpluged I cringe at the thought I left it in for so long. Hope I didnt hurt the motor.

Strange all the juices are underhood ... Not heard of issue wonder if ez only ??

Common problems with Edge EZ is that its mounted under the hood it get hot and cold. Then the case isn't sealed very good and I've several get water inside and corrode the circuit board... Edge Comp is mounted in the cab... No issues here...

I've been happy with a used one I bought,but I think I'll make sure it's sealed good against moisture,cause I can see that happening.:thumb1:
Go to topic listing