Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 07/26/2022 in all areas

  1. weird never heard that. My 92 which I sold had an aftermarket tank level float off of an old American car. the original Dodge Plastic float disintegrated in the fuel so I adapted the copper float to the sender arm and been in there at least 20 years. I know the new owner and he's had no problem. My 02 has had the copper tube (very short piece) in there since 2006. I just researched your info MoparMan, yes It is true, I had to see it for myself. Thank you for that.
  2. The butterfly valve. Typically the brake is junk.
  3. get a pair of mole grips or a wrench that fits the actuator lever and see if it moves, there is a spring in the canister so will take a little force to move , or if there is a little play in the actuator clevis pin you just might be able to see if it's free by wriggling it
  4. The pivot where it passes through the cast exhaust tube seizes, the shaft that the actuator rod connects to I have 2 here one is absolutly solid, one is brand new but no canistor
  5. . Lifted the engine just enough so I can scrape off the old gasket. Both engine mounts are 22mm. It's going to be fun to slip the gasket in.
  6. Me personally I would replace all vacuum lines making sure there is no cracked plastics or fittings. Even if you used a different hose and hooked from the vacuum pump and directly to the exhaust brake it should move. If not iveseen exhaust brakes that have seized from lack of use.
  7. 7 minute mark you show the splice in the fill hose and start to take it apart, then at 9:27 it repeats the 7-9:27 section. This is in the second vid posted. BTW, these videos are nice to see. Glad to know I'm not the only one that gets his hands and wrench in a tight spot only to realize it's the wrong size...🤣😂🤣😂
  8. crane did the job today It is the best most useful thing I think I've bought in a long time it's more than able to pick up from the right rear wheel area and into the bed without removing the tailgate had to remove the tailgate taking the rotovator off as no room on the right side really Definetly going to make a longer dipper for it
This leaderboard is set to Boise/GMT-06:00