Jump to content
Mopar1973Man.Com LLC

  • Welcome To Mopar1973Man.Com LLC

    We are a privately owned support forum for the Dodge Ram Cummins Diesels. All information is free to read for everyone. To interact or ask questions you must have a subscription plan to enable all other features beyond reading. Please go over to the Subscription Page and pick out a plan that fits you best. At any time you wish to cancel the subscription please go back over to the Subscription Page and hit the Cancel button and your subscription will be stopped. All subscriptions are auto-renewing. 

a short video of 3 cylinder idle..from the phone

white01
 Share

Recommended Posts

white01

white01

Posted
  • Author
Posted

Is that all you get for 3 cylinder??? :lmao2::lmao: That what I get with 6 cylinder high idle and the exhaust brake... You don't want to see my pyrometer touch 1,000*F with the exhaust brake, and the grid heaters because everytime the grid heater turn on the coal would roll... :stuned:

Link to comment
Share on other sites
  • Owner
Mopar1973Man

Mopar1973Man

Posted
  • Owner
Posted

Wow that is a lot more than I would've expected:stuned: I guess i need to get myself a scanguage to monitor that.

I've seen as high as 6-7 GPH worth of fuel being burned on a really cold morning like 0*F, 3 cylinder high idle, exhaust brake set and the grid heater draggin' the alternator hard and heavy... 6 cylinder high idle not so bad at about 2-3 GPH worth of burn rate but not creating as much heat and taking longer to hit the shutdown point... post-2-138698174051_thumb.jpg

post-2-138698174047_thumb.jpg

  • Like 1
Link to comment
Share on other sites
  • 2 weeks later...
dobienut

dobienut

Posted
Posted

I'm watching these videos of 3 cylinder idle and I wanted to ask something about it. I don't have an EGT gauge so I'm not sure what temps I hit , but under 3 cyl or even 6 cyl idle, is it safe to assume the EGT's will not get to hot if I start it, let it go into one of the idles (whichever outside temp it will make it go to) and let it go until it reaches operating temperature and kicks off on it's own? I'm not talking about Prowelder's high idle fooler, i'm just talking the factory enabled option.

Link to comment
Share on other sites
ISX

ISX

Posted
Posted

I'm watching these videos of 3 cylinder idle and I wanted to ask something about it. I don't have an EGT gauge so I'm not sure what temps I hit , but under 3 cyl or even 6 cyl idle, is it safe to assume the EGT's will not get to hot if I start it, let it go into one of the idles (whichever outside temp it will make it go to) and let it go until it reaches operating temperature and kicks off on it's own? I'm not talking about Prowelder's high idle fooler, i'm just talking the factory enabled option.

Link to comment
Share on other sites
 Share
Go to topic listing
×
×
  • Create New...