2nd Generation Dodge Non-Powertrain

Tried to look over some old discussions but cant find what I'm looking for. 99 24 valve with auto. Stock with about 150K on it. Sat for a few yrs till I started running it. Been doing ok, then started to "hick-up" or lope on me. Sitting idle or under power on road. Cant seem to understand. It'll just puff two three times in row. Expected it was a dirty injector. When I firsted started to run it 2 yrs ago I installed a draw straw plumbed into factory lines. Everything was good. I expected this was a dirty injector, started to treat with inj. cleaner. The "burps" kept getting worse to suddenly not starting after sort ride (warm). Ofcourse I expect no the lift pump, so I jus…

I have an Autometer fuel pressure gauge for my Cummins that constantly loses pressure the more I drive it. I seem to have a air leak and I have tightened every single connection. My T connector is between my lift pump and my fuel filter, is the best place for my T??I have a isolator on it. Fuel flows into a piece of equipment I bought with my gauges........so there is no actual fuel coming into the truck via the gauge.Should my T for my fuel be after the fuel filter?????

I noticed a little growl out of my power steering pump today. Checked the fluid and it was low and added some to it quit the little growl I was hearing. I have also noticed it growl a little on start up in the cold part of the winter. It always went away after warm up. How do you check the pump to see if it is going bad? I have also noticed some oil driping from that area and was thinking the seals are going bad. When I get home I am replacing the tappet cover gasket and will have that side of the engine pretty clear. Since I am going to be in there that deep I would not mind doing what ever I need to wile I have it apart.I have seen mentioned here before about a rebuild …

Was looking online to find some oem replacement headlights and the only ones I've found are from lmc. I've also found some on eBay but after searching I found out they are pretty much junk. Has anymore had experience with these before I pull the trigger on them. Thanks

someone running 265-75-16 on a 2001 dually?right now i have 235-85-16.

My fold down cupholders that I just took out of the truck had a little light that clipped into the top but im wondering if the map pocket I just replaced it with has a light too? There is a small square hole towards the top but I dont remember unhooking a light and I cant find one dangling behind the dash of the donor truck.

My issue started about a month ago. Up until last month i was able to Idle the truck with the A/C on with no problems of humidity within the cab. I am having the issue of not being able to cool the cab. The A/C clutch is working because i hear that thing engaging a block away:lol:. I start to drive the truck around and A/C comes back and starts pushing cold air again. Has anybody had this problem?

http://www.genosgarage.com/ISSPRO-EV-R30333-BOOST-GAUGE-0-40-PSI/productinfo/ISS-R30333/ http://www.genosgarage.com/ISSPRO-EV-R30033-FUEL-PRESSURE-GAUGE-0-30-PSI/productinfo/ISS-R30033/ http://www.genosgarage.com/ISSPRO-EV-R30033-FUEL-PRESSURE-GAUGE-0-30-PSI/productinfo/ISS-R30033/ http://www.genosgarage.com/NEW-Products/products/149/2/0 thinkin these may look nice on my a-pillar!

Well headed to the tire store today to get my trailer tire fixed and I come up on a lady at her mailbox on the left side of the road. Just as I get there she makes a hard left turn and came right across the road in front of me. I almost missed her by sliding up her drive way. No major damaged though and every one is unhurt. Her bumper caught my tire and ripped open. Got a little fender damage and my new taillight is broken. Anyway, my tires are about shot. I was waiting to buy some new ones when i got home, but now I have to do something. I have got my spare, it is the oe and almost new. How bad is it to run on new tire and 3 old ones. I have heard running differant diame…

Failed inspection today due to left hub bearing. I've been looking at RA.com and other sites, but can't seem to find a listing for a 4whl abs hub... Are they not abs-specific, like the 2001 was?

ok a friend is telling me its probably the orafice thats the problem any thoughts? pressure is good it takes a long time to get cold than it gets cold and sometimes not especially when you really need it i keep checking the pressure and its holding ok :banghead:

So, my '97 3500's airbag light is on. I assumed it was the clockspring, as that is a common issue that I've experienced in the past. I ordered a new one, and it arrived yesterday.Last night, I pulled the steering wheel. Low and behold, the clockspring was trashed..So, I replaced it with the new one.Started the truck up, AIRBAG light comes on, then goes out!!...Then came back on and stayed on.. :mad:Dagnabbit.. I need this fixed so I can get the truck inspected.. I printed off the wiring diagram, and the device components are pretty straight-forward:control moduleleft sensorright sensorclockspringdash lightIIRC, the airbag is 2ohm resistance.. Can anyone verify t…

A few months ago I lost the speakers on the driver side ,now I only have 1 speaker left on passenger side ,not sure if the problem lies in the radio or wiring?

I recently had to replace my steering box due to a broken output shaft. Put a upgraded Borgeson steering box on the truck that I got used for a good price. Worked fine on the truck it came off of. Ever since the brake pedal has been really hard to push initially, then when it gets past the hard spot in the pedal, the brakes seem to almost lock up and toss you into the dash. The steering assist is almost non existant at idle. The assist goes away completely when using the brakes. Steering acts completely normal driving down the road but the brake problem is still present. Just installed a new Borgeson power steering pump on to replace the old one per their recommendation. …

when i try to start my truck the starter soliniod fuse blows it started out as occasionally now does it all the time. starter was working fine just was blowing fuse on occasion should i try a new starter 1st.

My truck (1997) just started to have the death wobble only while braking. I only does it sometimes. The first time it did it the wobble was bad. There was no slight vibration that has built over time. I did recently replace tires. Do you have any words of wisdom?

i received my tow mirrors today and my question is, do i need the brackets you see for sale? they did not come with my mirrors. i am putting them on my 01

I recently pulled the bed off my truck to replace the brake line that runs between the tank and the frame. After I reinstalled the bed and connected the lights I have no tail lights, and my dash won't illuminate when I turn the head lights on. I do have brake lights, turn sigs. and back up lights. All the fuses seem to be good. Any suggestions? Thanks

I'm going to replace the upper ball joints on my truck (2002 2500hd 2wd) anyone have any tips pointers for this type job.Thinking i'll need to but weight of truck on jack stand or second floor jack to prevent spring from pushing to ground once the upper ball joint is broken loose ?The rivets drill out or cut out tops of rivet with dremel tool, any easier methods for this ?Any suggestions appreciatedThanks in advance,Tony

My A/C, when left on after I cut the the truck off and restart it, sometimes resumes in the defrost mode and then after moving the truck, it will return to the normal mode for Max Air. It will not return to the Max Air mode by just rotating the dial. Please advise.