Anyone here rebuilt there hx35? I guess I’m going to attempt it myself tomorrow. Any tips or suggestions? Hope I don’t mess anything up. I plan to check for boost leaks before I rebuild it. Anyone have a diy tester they have built? 

Thanks for the info Ben! I was never aware that injectors responded better in a HO pump. Iv noticed hat although the injectors add 75 hp a can bus 65 hp tune has wayyy more umphh than the injectors. 

 

SO = 235 HP / 460 TQ (16.3:1 Compression)

HO = 245 HP / 505 TQ (17.0:1 Compression)

 

Not like its a whole lot of difference. 

@Marcus2000monster I see you have hx35 kit up for sale.  I thought at one point you said your turbo seals were leaking. Did you replace your turbo, did I misunderstand or?

1 hour ago, Royal Squire said:

@Marcus2000monster I see you have hx35 kit up for sale.  I thought at one point you said your turbo seals were leaking. Did you replace your turbo, did I misunderstand or?

Decided to wait for now. I think the oil might actually be from the old s&b oiled filter.

Ok. Just curious 

On 4/29/2018 at 4:00 PM, Ben said:

• ETH injectors (3946306) flow 600cc at 100bars for 30 seconds
• ETC injectors (3944828) flow 640cc at the same test.

 

SO vs HO injector nozzle if I remember right there is a very small nozzle size difference. Less than 1 thousandths of a inch between the two. Again nothing to jump up and down about. 

 

Tidbit. HotRod VP44 is the fact of mixing SO and HO pump parts tougher. Your totally gains is +21 HP typically and that HO advanced timing and like I will no advise using a tuner with timing against Hot Rod pumps. I've ran across on case where in the dead of winter it was creating a no start issue because of the excessive timing. (Hot Rod Pump plus tuner).

On 5/1/2018 at 2:34 PM, Marcus2000monster said:

Decided to wait for now. I think the oil might actually be from the old s&b oiled filter.

Have you tried cleaning it?

11 hours ago, BBHD said:

Have you tried cleaning it?

The filter? I got rid iof that POS immediately after I bought the truck. 

I’m assuming he’s talking about the oil you saw in/around the turbo 

4 minutes ago, notlimah said:

I’m assuming he’s talking about the oil you saw in/around the turbo 

Nope I haven’t done anything. Should I be doing something? 

I mean, if there’s oil in/around your turbo and I’d at least clean it and see if it comes back. How else you going to know where it came from?! Lol

10 minutes ago, notlimah said:

I mean, if there’s oil in/around your turbo and I’d at least clean it and see if it comes back. How else you going to know where it came from?! Lol

Haha I get ya!