2nd Generation Dodge 24 Valve Powertrain

My 2001 RAM 2500 24V Cummins Automatic (56K Miles) goes from dead pedal starting at 2000 RPM in 1st gear to having the transmission disengaged above 2000 RPM. Sometimes I can rev the engine but it acts like the truck is in neutral. The truck will drive in first gear, as long as I stay under 2K RPM. I have replaced the APPS, same problem. The error codes are:P PCUCP 0720P ECUP 1693 Any help would be greatly appreciated.

So, I'm not getting into specifics, but I goofed. I was backing into a shop parking lot and from the first angle, there was no way I could have seen it... I backed into a freakin light pole... :eek::whistle: Now, this would not have been much of an issue, but I was backing into a parking spot off my passanger side mirror completely hiding the pole coming up on my driver side as I was turning into a spot... At the moment the pole was visible in my driver side, I was already into it. I caught the far corner of my bumper which pushed in and turned the fender under, cracked the tail light and really pissed me off. So, if you were going to buy a - Driver side back fender- N…

OK so I'm up in the hills hunting and the high of the day is usually 8*f ..so as I'm driving down the hill and i take a hard left on a switch back.when its time to go straight it doesn't center back up??????i have to stop the truck and turn excessively right then everything is normal.i cant figure out if it is my steering box or has something to do with my four wheel drive.it only happens when I'm in 4 wheels and really cold.any ideas?

When I use the 4wd the light in the instrument panel has a mind of it's own. I am going into 4wd fine but when i first used it, the light wound not go out when i shifted back to 2wd, until i guess it shook whatever sender it has free (Gumed up?). The other day it didn't come on at all when i was in the snow in 4wd. Does anyone have any fixes or test? Thanks for any help. just want it to work the was it is suspose too.:confused2:

I know a bunch of you are looking for books for your trucks I'm going to list the source of the books I know and were to get them... PDFTown.Com http://pdftown.com/Pdf-eBook/Dodge.html Or check here too... http://forum.mopar1973man.com/downloads.php?do=cat&id=2

This is new... When I start up in the morning and go into gear, the engine seems to want to die. Basically, sees like the trans is grabbing too much...any ideas?

So i got my first ever owned diesel a 1999 dodge 24v diesel w/ 235k miles on it. It has a bit of troubles here and there. Ive noticed that since I got it for such a steal of a deal so i cant complain about its troubles. But there are a few, first off from roughly 1 1/2k to 2k rpm the tranny seems to have trouble getting up and going it feels like it is slipping, the other day i had it in 4 hi and i was trying to reverse up a hill and it just felt like it was going no where the motor sounds healthy. I know this truck has a lot of power that i am not seeing because of the transmission slipping. Another thing i have encountered is my keyless entry for the truck when i press…

Ok so Hello everyone.....Yes I am a Newbie. I just bought a 2002 one ton Dodge ram from my company. It has 240k miles on it. Tranny needs some work one of the guys popped a cooler line and drove her dry. I fixed the line and filled her back up and she still rolls down the road just not as strong as she should be. My problem is I know the tank is dirty so the filters get plugged pretty quick which is why she will start to kind of cut out every so often, I try to keep the water drained, but the other day I was rolling home from NC and she chugged a couple of times then she just quit on me. Now this has happened before while the company owned it and I know it was a quick fix…

Hey,I'm going to change my power steering pump with a high flow PSC one and put a cooler in line. I'm wondering how much fluid will I need??How much did the stocker hold???Thanks,Winslow

Where can I order a pump at a reasonable cost 2001 V44:ahh:

Ok, so here's the deal. I took my truck on a 1200 mile round trip to see family for thanksgiving, and on the way there the truck ran great. I averaged 19.67 MPG, but I was empty and not pulling a trailer. So then on the way back I was pulling a 24 foot flatbed trailer hauling a steel flatbed that I am going to put on my truck (weighs a couple hundred pounds). The truck had no power and got 10.32 MPG on the return trip. Also the ABS and BRAKE lights are now on and when I rev above 2300 RPM's I can hear a hissing noise from behind the dash, it sounds like it is comming from right behind the airbag on/off switch area, but it is hard to tell for sure (also it makes this noise…

Does anyone have a picture of the pinouts on the pcm?I am looking for #23 orange wire/dark blue tracer.I have a picture of the in's and outs's on a wire diagram,but i am looking for a number block to help me get there faster.Thanks in advance.

So, I'm thinking about paying santa to being me a new set of nice guages this year. I have a mix-match set in a 3-pod pillar right now. So, who makes the "coolest" gauges around? I'm running a pyro, fp and boost.

I have never had a fuel leak, but low and behold... When I power down, I get a drip off the bottom of the transmission.... I put a cup under it and collected a small amount, but enough to realize it sucks... Seems to be related to pressure in the lines as it stops after 10-minutes or so. Any ideas where to check for the most common fuel drips? :confused::confused:

Evening, all.My batteries aren't getting charged up. I had a local garage (the only garage in town) change the alternator, as they'd indicated it was bad. No, the batteries are still not getting charged. They replaced a wire from the alternator, as they said the connector was fried and corroded. When I started the Dodge up, I noted that the ammeter was just barely above the 12 amp mark (left white hash mark). I pointed that out and they said it would rise, that 12 amps was within spec. I drove around town a bit (small town) and saw that the ammeter wasn't rising at all. I took it back to the garage and they said it might be the batteries. They're fairly new (1 year old) L…

I just replaced my VP and although it starts much better, there is still the 5-8 seconds of cranking to get her going.... I have read that the fuel pump should not be running while cranking, but I'm pretty darned sure mine is...I don't want to hurt this VP. Should my FASS150 turn off while cranking and then pump once it fires up????I'm jealous of Mike's video where his truck fires in just 3-rotations....

in the last 2 months this has happened 3 times. i am cruising along the freeway and bam...it fells like a miss...the truck lunges and then takes back off. it lasts just a split second. the first 2 times i had cruise control on. usually travel 60-65mph. it did it again after coming home from a hunting trip and i wasn't using the cruise and was going ~75mph. no CEL light, so autozone won't even try to read codes...just left me scatch'n my head.

Mike, This is my friends truck that I'm checking out now, he had posted this comment on another forum. (see below).I have a 2002 Dodge ram 2500 diesel that I am pulling a map and iat sensor code on. My mechanic thinks it is the ECM but is not sure. I only have about 1/4 of the pedal and then nothing happens after that. If anyone has had this problem and could help me I would appreciate it. Thanks Mike, I'll have to post this in a series since it has a bunch of info on it.Mike, all this took place before I actually had a chance to do any of the diagnostic testing listed below. This is what happened before I got my hands on this truck. Every one who or where he has drove th…

First, this problem only happens after it sits over night. If it sits 10-12 hours during the day it starts right up. Second, I have no codes, cleaned the battery terminals and used dieelectric grease on the the fuel pump electrical wires. Third, checked the 40 amp fuel fuse at the PCM.Fourth, fuel pressure is 17 psi at idle and driving and 15 psi at WOT. This problem is on a 99 2500 4X4 auto with an Edge EZ and a Raptor 150 pump. I believe it is an electrical problem. Here is the problem: turn the key in the morning, pump energizes, start the truck up and it runs for approx. 10 sec., shuts off, turn the key off and then back on- you don't hear the pump energize, turn the …

I am trying to find an OEM replacement kit for the fuel heater element on the fuel filter cannister for my and my wife's truck. I am getting reading that these are getting very difficult to get and are no longer in production??? Is this true??? :confused: Anyone know where they can be purchased? I understand they are a Cummins Filtration item and the part number is: 3928013-S Can anyone verify this or provide the correct part number? Thanks.