2nd Generation Dodge 24 Valve Powertrain

Well I called Airdog today and they do not have a bracket for a '02 short bed Ram:(. I really want to put the Airdog 150 by the transfer case, not in the path of wheel debre from being outside on the frame. Does anyone know where one is or have any specs on one that they use/built? I think if someone wanted to make a few of them there is plenty of people that would buy them.

i assume my vp44 is dead i need help with a new one and dont have alot of money is it hard to install aswell

Alright been messing with this for a couple of weeks. Started when it first got cold. Noticed my heat was not as warm as usual. I checked my radiator and it was about half gallon low. After I filled it up I drove it and the heat seemed to be better. When I got home I noticed some antifreeze on the ground. Looked up there and found it dripping from the drain plug. Replaced the plug which I might add is a stupid design and pretty much worthless to actually drain your radiator. Why cant it be a pitcock drain. NOOOO it has to be some nasa frickin design with an O ring that doesn't actually work after you remove it the first time. :banghead: Sorry !! Anyway it wasn't the plug …

I hope this was the right thing to do... It seemed like too good a deal to pass up. http://www.cumminsforum.com/forum/98-5-02-2nd-gen-all-products/342727-2000-02-hts-47re-ultimate-duty-valve-body.html I have other irons in the fire first but will need to eventually upgrade the 47RE.

a/c clutch is cycling when heat is on. I'm not talkin defrost just regular heat.

Hey guys i have noticed this odd fluctation the last two days with my fuel pressure. What I am seeing is my pressure go from 16-18 psi then it usually starts to fall off when i am slowing down to stop, i will see anywhere from 2 to 5 to 7 to 10 psi with absoutely no engine indication that this is actually happening!!! (i think maybe false indication???) my fuel pressure has always been very steady until last night and today. :banghead:

Crank seal & timing gear cover gasket install For any one here that has or had or will have a leaking CRANK SEAL or Timing gear Cover...check out the link below..."hope it works" LOL. I installed mine a while back and took plenty of photos incase any body else had to do this, it might make it easier... http://s1209.photobucket.com/albums/...eal%20install/ SLIDESHOW VIEW http://s1209.photobucket.com/albums/...view=slideshow Richie

I am going to do the 930k service this weekend. I will change the trans fluid, oil and coolant. Other than that the truck is running great.

New owner & still getting accustomed to my truck ('99 3500). I was reading another thread here in the 24v powertrain forum & the poster mentioned the check gauges notification coming on in his cluster, as if that was an indication of a problem. I noticed this notification on my truck; it will temporarily illuminate immediately after start-up (all gauges indicate normal), and will go out after about 5 seconds or so. I figured this was normal operation but after reading about all the troubles the other fellow was having I now wonder if it is. Is there anything I should be following up with? Appreciate your patience & help, Joe in St Louis

For any one here that has or had or will have a leaking CRANK SEAL or Timing gear Cover...check out the link below..."hope it works" LOL. I installed mine a while back and took plenty of photos incase any body else had to do this, it might make it easier... http://s1209.photobucket.com/albums/cc389/rburks1/Crank%20seal%20install/ SLIDESHOW VIEW http://s1209.photobucket.com/albums/cc389/rburks1/Crank%20seal%20install/?albumview=slideshow Richie --- Update to the previous post... I apologize Guys.. the photos are not any order like from start to finish...i tried to do this 3-times and thought i had them arranged that way but after i post…

This morning I started my 01 3500 like I do everyday. Everything seemed normal, after about 15 mins. of warming up, I got back in the truck to a check engine light. I checked the codes, I had two (P0237,P1693). I drove the truck and had no noticeable signs of problems. Is this something I need to have checked out? Any help Appreciated.

Think I am going to do this.Found this turbo - its a reman off a FEDEX truck.I am 99% sure its a HX35WJust wanna see if anyone knows if it will fit -> looks like it might be missing the part from the exhaust turbine back to the downpipe ???? If so - does it have a name and where can I get one - or can I used my existing one ?? :shrug:Basically will this work.

Hey its just recently gotten cold here and Ive noticed when it has set over night and is cold when it first starts up is blows some blue smoke. I was wondering if this is normal or not. It does it when it gets less than 20 degrees and goes away after a few minutes. I have a basically stock truck just wondering if this is normal or not and what causes it. Thanks

How trust worthy are these things? I found a 01 eng. with 48k miles for 5k shipped what you think? My plan is to buy another eng. and rebuild my eng. a little at a time. Maybe find another truck at some point that needs a eng.

Going to get a boost fooler,just getting opinions on which is the best one. I have an 01 H.O. that is getting RV275's put in and a boost elbow:shrug:

Do the cummins brand of t stats have a fail safe?The question is when they go bad are they made to brake in the open position? My engine gets hot 190.The t stat housing is hot. The radiator fluid is cold.I am thinking water pump. The radiator and heater core were flushed in summer.

Took my truck and trailer (trailer rated for 14000kg) and drove 3.5 hours to pick up a backhoe attachment, drove back. Filled up and checked my mileage and was very dissapointed to see the result! 11.6 mpg

Now that it is getting colder outside I'm preparing to change oil in my truck. I live in Illinois just East of St. Louis. Occasionally the temps will fall below 10*F which is out of the 15w-40 range according to the chart. I'm curious what some of you guys do regarding oil changes and viscosity? Do you change oil in the fall to 10w-30 and then again in the spring back to 15w-40? I know I can buy 5w-40 but all I've seen is a full synthetic. I only put about 6k on my personal truck in a year, so when I had my gasser I would change oil at the 3k mark. I've only got about 2500 miles on this truck since the last oil change. I hate to change oil unnecessarily but again…

My exhaust manifold has a small crack....doubt there is any way to repair this besides replacement.Anyone have suggetions on what aftermarket manifold to buy? not sure what mods I will end up doing to this truck down the road....nothing to extreme though. Just want somthing that will help it breathe better,won't crack and won't brake the bank

Just took my truck to the voltex battery today and had new batteries installed, I figured its about time the old ones were 6 years old and weak. They put it 2 of the 65 group size blems (2nds) for $35.00 each, left there with $75.00 out the door with a 1 year warranty . I work at advance auto parts, part time and they are $90.00 each with my discount. If anyone has a battery store that sell blems that will save you a lot of money.