2nd Generation Dodge Non-Powertrain

Could someone look up the fuse location for me. I need to know where the fuse is for the trailer running lights. I've still got taillights on the truck and all work fine. No running lights on the trailer. I've got turn and brakes on the trailer. I'm in the field and don't have my books with me.

I may not explain this good but here goes. I need to test the alt for feed back, my apps or something is causing it to feel like its running out of fuel. It doesn't cut out hard, it has that running out of fuel feel to it. The more you mash the pedal no help its dead, let it all the way up then start back into it and it will either accelerate or you have to let it up again then it will run ok. It may run all day and never do it again or it has done it 1/2 dozen times. No codes, well it has a 1693 but nothing in there. I have put three diff. apps on and they all do the same. Fuel filters are clean, fuel pressure is 15. I just cant find the write up. Thanks

Ok. Everyone knows I just replaced my front two ABS sensors. Here is what happening now. Start up roll out slow speeds less than 40 MPH the ABS and BRAKE lights remains off. Once I exceed 40 MPH they pop back on. I can pull over shut off the truck start up again and start rolling out and the light reset again. Once over 40 MPH it trips again. My old sensors works fine but had been broken in the leads. I solder and shrink tube then a few times and always was able to get the light back out. As for the rear speed sensor it dead on with my Garmin GPS so I really doubt I got a bad rear sensor.

Am tired.... and its getting worse and worse of fiddling with the damm plastic lenses on the headlights on my 2002 2500 truck. Clean them off and they look great and I can actually see at night, then another 2-3 months later and the damm plastic gets hazy again and its time to do it over again. Was chatting with a guy on CL and he mentioned upgrading the truck to something like the 2005 style of headlights and be done with these older headlights. Anyone else do anything like this? Thx, FT

My speedo , Tach , amp and temp gauges ,brake and air bag light all quit working at same time. Oil pressure and fuel gauge still work .

I have seen a few trucks with 2 holes drilled in the exhaust manifold and one always has a copper loop like a still. What is it? Why? You can see it here: http://articles.mopar1973man.com/2nd-generation-24v-dodge-cummins/26-engine-systems/482-holset-he351ve-install-retrofit-2nd-gen-cummins

I found a small wire loom hanging from the truck which and one time was up under the hood. I dont know what it goes to but i traced the loom back to a connector in the drivers front wheel well between the inner fender liner and the fender at the front of the door. It is the single red wire coming out of the loom. On the way home my tranny temp gauge went nutty. Should not have anything to do with the above since it is not factory. I got home shut the engine off. Restarted a couple minutes and it was working fine. Coincidence ??

In my 40 years of vehicle ownership I've never had a rig that is so needy towards tightening the upper radiator hose. I start getting drips at the post office prior to full warm up about every 6 weeks and need to tighten the hose at the thermostat. Any ideas why?

Anyone have a source for them for a 99 truck? I can find 01 and up but none for 99. It's all coming apart for ball joints soon so now would be a good time to get some back on.

I'm curious to know of the 4 wheel ABS system can be retrofitted onto a truck with a 2 Wheel ABS system. Anyone know if it's possible?

As the title states I have a chirping squeak under acceleration never heard something like this and whats worse is it is in the cab within the dash. Also the forward dash screws keep getting loose definitely becoming an annoyance any clues as to how to keep them tight and what may cause a chirping sound in the dash?

Hi Guys, My 2002 truck still has the original batteries in it. While the weather is mild they are still giving good service - but coming up to winter I am not so sure this year. Those of you that have replaced your batteries, what did you use and how have they performed. I am considering going to Costco for the new batteries as I have had good results with their batteries on other vehicles and applications. Any info or recommendations would be greatly appreciated. Thanks

My low beam on the passenger side is not working but works when you turn on high beam. Is this from a short in line somewhere or switch or what? Has anyone else had this kind of problem. I have changed the sockets out with new ones, checked for shorts (as good as I can while on the truck) on the harness but nothing to obvious. let me know what y'all think

I just changed my heater core and I went ahead and changed the ac evaporator. I have leak somewhere in the ac symtem I haven't taken the time to find yet. I didn't use the ac at all this summer. Winter is coming so I figured I'd wait to spring to fix it. My question is will it hurt anything by leaving it empty with no freon while running the heater and defrost? I've heard that the ac might cycle on when the defost is on.

You'd think I could remember after all these years but after all these years my forgetter is getting better! Some tires have a dot on them for mounting. The dot either goes at the valve stem or 180 deg. from it. The dot either shows the lightest or heaviest part of the tire but for the life of me I can't remember and I have 2 tires to put on my Kawasaki this week. Thanks for setting me straight.

I have a 99 automatic and a brand new 15x5 SLM Enclosed trailer. The brake lights and turn signals work but the trailer has a bunch of LEDs and other running lights on it and they don't light up. They won't light up on my buddies 2000 24 valve dually either. Only the brake lights and turn signals work. So I'm curious if any of you guys have ran into this before. It's a 4 way flat and I'm using an adapter to plug up to the stock plug that comes on our trucks. I tried to call SLM but they are closed until Tuesday. I wanted to try to figure out what's going on this weekend. Any ideas?

Hi, does one one know the brand of sun visor installed on these trucks ? Thanks

Anyone know if the front bumpers and fenders are the same the whole way through the 2nd generation (94-02) ? I may have found a parts truck but I'm pretty sue it's from the 12v years and I thought I read one time the fenders were different.

Mike has answered all my past questions but here are some more. You guys probably don't believe that I was a diesel fleet mechanic and shop superintendent for 30 years. I think I have forgotten more than I ever learned and this new stuff has just passed me up since my retirement. Question: I have a vacuum pump that sucks 20 inch of vac. Is that enough to vacuum an AC system after disassembly? At NAPA buying my evaporator and thought I would just buy some compressor oil while I was there. There are 4 different kinds in the same brand. Which type do I use? I really should bring this truck up to mike and have him show me some spots to hunt chuckars with my bird dog before I …

I am looking at buying a 2002 Ram 2500 HO 6 Speed with 235,000 miles asking 7,500. It seems to have been reasonably well maintained the owner has allot of service receipts. Here's a few pictures of the truck body is really nice (all redone last year new fenders ,doors, bedside and complete repaint...) but the underside worry's me...just want some opinions. Here's a few pics Thanks !