Quadzilla Power

If this is in the wrong place sorry, please move. @Mopar1973Man @Me78569 @dieselautopower Quadzilla Adrenaline V2 has started kicking on high idle when its past the set point of 160°. Engine temp on Quad and autometer both show 180+ and it will turn on. If i turn off high idle in settings it does stop it from turning on. This started out of nowhere about 3 days ago. I left it off overnight and it worked correctly for 1 drive then this morning started doing it again. It has also started displaying the wrong gear. Driving with shifter in D it will show 1,2,3,4. As i come to a complete stop it shows 4,3,2,1,3,4,L. Shows L until i start moving again. In…

Ok guys bought my truck with a quadzilla on it and I'm not a big fan of it. How can I remove it from the truck? Can I just unplug it from the map sensor and then all the other wires or do I need to take it and have it refreshed? I'm assuming the VP44 wire has been tapped but haven't looked?

I've seen this mentioned in other threads, but has anyone looked into it yet? It seems ever key-on the gallon trip is reset no matter what the toggle in the iQuad app is. I tried reinstalling the app from the PlayStore, and I have the adjustment set at 140%. It was set at 135% as well and was doing it. When I first had the feature it was all default and wasn't resetting. I actually had a hard time figuring out how to reset it at first. I just went for a drive and did a pretty quick key off while I was going down the road, and as soon as the key was back on the gallons were reset back to 0. iQuad app didn't go through it's long connection setup either. …

So I been in a love/hate relationship with my Iquad for a year now. Today I decided to give it one last try. I uninstalled and reinstalled Iquad app on both my Android devices. Downloaded the tunes directly from this site I wanted and added them, and added, and added. The only one I downloaded would not show up in either device. When I went to import the tune for the second and third time's. It popped up the file already exists BUT it would not display under custom tunes! So I got to looking at vehicle selection. That's where I saw the differences between devices, same version number. Different title. See pictures There is also additional Quadzilla test V2 selec…

I've been messing with my daily tune and have a few questions (elev 3800ft). I have a compound turbo setup with 175hp 7x011 voc injectors. I am tuning for smoke mostly. I've got most of the smoke out of my tune except for start up (I'll ask about that later) and low psi, mid to high load situations while cruising from town speeds to sub highway speeds. One thing that's a little troubling is that my current can bus fueling is way below what the tune builder suggests. I've started as high as 75, however, I get pretty decent clouds of dark drey smoke when I accelerate with more than 30-40% throttle from cruise. I've dropped the load timing down to 1* and gone as high as 17* …

The quad is saying that the transmission slip is at 100% but transmission seems to be fine no problems

I’m working on figuring out a way to use an Android device and have it come on and off with the key switch. I have no clue how to go about this. Any suggestions? I think I have found a way to make it autostart a certain app namely IQuad of course so that part I can work with.... hopefully within a month I can afford a Qaud!

*****solved! 1-30-20 5:50pm** dielectric grease in all the connections solved what was a bad map connection ?? Thanks everyone! 2002 24v 2500 I just bought a quadzilla with iquad from from someone on here, I connected it as per the instructions(they were included) and I’m having some issues. First issue I would have to guess is causing the 2nd. - with the truck idling I’m getting a high boost warning. It says I’m at 48-50 psi at idle, and doesn’t change while driving. This is the “default profile” for the 98-02 v2 version 2.7. I’m assuming because of this, it’s the reason the level selection bar is “yellow” and I cannot select different power levels. - I…

Ok. I've still got this issue and very annoying. This is an LG G5 phone and its brand new not even a year old. Now the issue is Bluetooth is hanging up on any custom tunes. So if I do like I normally do on my trip back and forth from Ontario, OR. I'll set up at home and fire up the iQuad app but it might nearly 20 miles of shutting down and starting up before I get iQuad to hook up on bluetooth. So like every 4-5 miles I shut the app down and fire it back up. I'll get a quick message about couldn't connect to device. By the time I get to about New Meadows 20 miles away it might hook up. Now if I want to for sure hook up first time then…

So i had to disconnect my batteries today because I had to pull the passenger side airbag to work on the heater. I disconnected both positive cables, and unplugged the Quadzilla. When I hooked everything back up, I plugged in the Quadzilla last. Now where the power level is, the bar is black and it's showing zero. Please tell me I didn't fry my module again.

Can someone please explain what the High Idle Delay Setting is used for on the Quad and Warm Up Mode Setting. I am guessing the High Idle is used possibly to help volts for accessories?? I am also guessing the Warm Up Mode lets the truck warm up if its cold outside, but does this mean if I set it to say 195 degrees the truck can not be moved until it reaches this temp? Trying to still figure this out. Thanks for any help getting me to understand this!

Good afternoon everyone, I did some searching on the site before posting, but would like some other insight. My truck bucks between 40 and 50 mph and rpms are around 1100-1200 on level 2 and 3; I have not gone above level 3 as pump is not tapped. I feel it may be timing related as it did not buck today when I had the Quad on level 0. Current tune set up is below. Do you guys have any suggestions where to move timing to stop the bucking? Tune: Mopar1973man Economy Tune Max Load Timing Offset: 1 degree Low PSI Timing Reduct: 3 degrees Timing Reduct Scale: 40% Light Throttle Timing Adv: 1 degree Light Throttle Load Limit:…

Hello @Quadzilla Power, I really think it's time we deal with this problem. I've brought this up in the past, but I haven't pushed the issue hard enough. I'm willing to lend some time to help with this wherever possible. I know this is a common problem, and I know it's isolated to the iQuad app. On my Android device in my truck (Android Head Unit), running 4.4.x or 5.x.x, iQuad will not see ANY bluetooth devices. The app itself, has no communication with bluetooth devices. I can even pair the iQuadBT device, no problem. Pairs fine. My phone pairs fine. My OBD2 scanner pairs fine, and works with Torque Pro. I have taken the necessary steps to make s…

For some reason my quadzilla shows my coolant temps dropping to zero for a second then jumping right back where its supposed to be. Kinda aggravating when its warmed up then jumps back to warm up mode...any help or ideas other than turning off warm up mode is much appreciated.

Ok soo I’ve asked the admin “me**” about this but he doesn’t have a iPhone soo my issue is I can’t import tunes on my phone from the quad app.. (I tried deleting and re downloading I’ve also restarted my phone) it just gives me the option to make my own customization well any help would be great full because the stock box is kinda boring it’s a brand new box btw just installed yesterday on the truck. It’s supposed to be a 4K box. Here are some screen shots

This is pointed towards @Quadzilla Power for suggestions... Bluetooth connection problem needs to get fixed. Quadzilla is the only thing with serious connection problems. Bluetooth connection cycles once then stop trying to connect. Takes several tries to get a connection. Mobile device needs to remember last display used. Always have to swipe to the second screen. MPG data erased every key on cycle with 2.8.4 Firmware. MPG data not an option for the normal vehicle selection. ECM/Quadzilla fighting at low throttle (getting worse the better my economy tune gets - bucking) Need to add audio alarms to the Quadzilla (Cute fem…

Should I unplug my quadzilla before getting the ecm flashed for the factory high idle? 02 truck so it might not need to be flashed just the options selected.

When tuning the canbus fuel percentages at each PSI - does anyone have any data recorded on what percentages can reach a maximum fuel command (4095) at full throttle? Example: If the 30+ psi setting is set to 100%, there should be stock fuel. Full fuel command would not be achieved, even at full throttle. What about 110% or 120%? I'm thinking around 128% with some fuzzy math I did. But I'm curious to hear about the findings of others.

Looking for some good custom tunes. Econ. DD. Race. Smokey. All kinds. New to this type of tuner just trying to get the feel for it.

Anyone compared mechanical gauges to the quad I'm wondering if the quad is accurate on the EGT especially ??